SCHOOL BUS DRIVER SEAT ASSY MANUAL

(2) The seat belt anchorages set out in subsection (1) and the owner’s manual for three-wheeled vehicles, passenger cars, multipurpose passenger vehicles, buses other than a school bus, and trucks with a GVWR of 4 536 kg or less must conform to the requirements of Technical Standards Document No. (b) if a Type 2 seat belt assembly has been installed, seat belt anchorages for a combination pelvic and upper torso restraint.(a) if a Type 1 seat belt assembly has been installed, seat belt anchorages for a pelvic restraint or.(26) Until September 1, 2020, buses may conform to the applicable requirements of this section as it read on the day before the day on which this subsection came into force.ĥ Section 210 of Part III of Schedule IV to the Regulations is replaced by the following:Ģ10 (1) The following seat belt anchorages must be installed in a designated seating position in respect of which a seat belt assembly has been installed under section 208: (3) Subsection 208(26) of Part III of Schedule IV to the Regulations is replaced by the following: (c) cannot be detached from any anchorage point.(b) can be adjusted by means of an emergency-locking retractor or an automatic-locking retractor and.(a) has an upper torso restraint that cannot be detached from the pelvic restraint.

(6) Every school bus, transit bus, perimeter-seating bus and prison bus must be equipped, at the driver’s designated seating position, with a Type 2 manual seat belt assembly that (2) Subsections 208(6) and (7) of Part III of Schedule IV to the Regulations are replaced by the following: (a) at each designated seating position, except those referred to in paragraphs (b) to (d), with a Type 2 manual seat belt assembly that.(5) Every bus, other than a school bus, transit bus, perimeter-seating bus and prison bus, must be equipped (i) the words “THIS VEHICLE WAS ALTERED BY / CE VÉHICLE A ÉTÉ MODIFIÉ PAR” or “ALTERED BY / MODIFIÉ PAR” followed by the name of the company that altered the vehicle,Ĥ (1) The portion of subsection 208(5) of Part III of Schedule IV to the Regulations before subparagraph (a)(i) is replaced by the following:.(6) Until September 1, 2020, the number of designated seating positions referred to in subsection (5) may conform to the requirements of this section as it read on the day before the day on which this subsection came into force.ģ Subparagraph 9(1)(c)(i) of the Regulations is replaced by the following: 222, School Bus Passenger Seating and Crash Protection. (5) The number of designated seating positions in a bench type seat in a school bus shall be the number of seating positions determined in accordance with Technical Standards Document No. Prison bus means a bus that is specially designed for the purpose of transporting inmates ( autobus pénitentiaire)Ģ Subsection 2.4(5) of the Regulations is replaced by the following: Regulations Amending the Motor Vehicle Safety Regulations (Bus Seat Belts and Other Amendments) Amendmentsġ Subsection 2(1) of the Motor Vehicle Safety Regulations footnote1 is amended by adding the following in alphabetical order: Her Excellency the Governor General in Council, on the recommendation of the Minister of Transport, pursuant to subsections 5(1) footnotea and 11(1) footnoteb of the Motor Vehicle Safety Act footnotec, makes the annexed Regulations Amending the Motor Vehicle Safety Regulations (Bus Seat Belts and Other Amendments). Regulations Amending the Motor Vehicle Safety Regulations (Bus Seat Belts and Other Amendments): SOR/2018-143-2Ĭanada Gazette, Part II, Volume 152, Number 14

School bus driver seat assy